There are many models similar to the Husqvarna Ezc4824 Cero Specifier. These include the Iz4821 Husqvarna and the RZ4824F Husqvarna as well as the Husqvarna RZ4623 Zero GiroCésped Cortation. The Zero EZC 4824 spi n-spi n-spi n-spin uses a Kohler Courange Pro bicylinder engine to propel the rear wheels as well as the cuttin g-edge platform. The power of the Kohler Courage Pro engine is transferred to the wheels through a Dual ZT2800 hydrostatic transmission. This transmission is controlled by 2 bars located in front of the operator. The right bar controls the right rear wheel, while the left bar controls the left wheel. Pressing the bars in opposite directions, you can quickly and easily perform a Radio Zero turn. The ZT 2800 transmission provides the corteped with a maximum speed of 11. 3 km/h (7 mph).
The engine also operates the Husqvarna EzC4824 Cero Specker Platform. The cuttin g-edge platform is 60 inches wide with the downward plastic discharge protective lid. However, the total cutting width of the platform is 48 inches. This platform contains 3 separate blades, each of which has a length of 16. 25 inches. The platform can be lowered and climb in a 3-inch range, from a minimum of 1. 5 inches to 4. 5 inches above the ground.
The total weight of the Husqvarna EZC4824 is 290. 3 kg (640 pounds). The front wheels of the EZC 4824 are quite small, since they do not have to endure too much weight. They measure only 11 × 4-5 (11 inches in diameter, 4 inches of width, 5 inches in tire diameter), while the rear wheels, which do most of the work, are larger and measure 20 × 9. 5-8 (20 inches in diameter, 9. 5 inches of width, 8 inches of tire diameter). Have you used the Zero EZC4824 Giro Specked? If so, we want to know his experience with him. You can leave us a comment below.
