A corteped very similar to Poulan Pro 461ZX is the zer o-pouco pro 460zx gyrus cutting, since both have the same cutting width and have engines that produce the same power. The PRO 461 ZX engine is a Professional Model Series of Briggs and Stratton. This ai r-cooled engine has a power of 19. 5 hp. The monocylindrical engine is started by key using a 12 volt battery. This battery is recharged by an alternator of 16 amps once the engine is running. The fuel tank of this cortesped can contain up to 13. 2 liters of gasoline.
The Poulan Pro 461ZX uses a dual hydrostatic transmission Hydro Gear Ezt to bring the power of the engine to the wheels. This ventilator refrigerated transmission is what allows the operator to make radio zero turns using the back bars in front. The maximum speed of pro 461 ZX is 9. 7 km/h forward, while back is 4. 8 km/h. The cutting platform of this corteped has a 4 6-inch cutting width. The cutting platform can be raised up to 4 inches above the ground and lower to 1. 5 inches above the ground in hal f-inch increases. The cutting platform has 2 blades.
If what you are looking for is something more powerful than the Poulan Pro 461ZX, take a look at the Poulan Pro 540ZX or Poulan Pro 541zx. While if you are looking for a zer o-rotation corteped with less power and a minor cutting width, then you should take a look at Poulan Pro 380ZX or even Poulan Pro 301zx. Please leave your opinion on Pro 461 ZX below in a comment. Try to include both what he liked and what he did not like to give a good general opinion.