The Husqvarna GTH2754 Speaker Tractor uses a Kohler gasoline engine with cylinder head valves. The engine uses a full pressure lubrication system to keep everything working well and friction free. The engine is started by a 1 2-volt battery that rotates the engine with 280 cold starting amps. The battery is recharged with a 13 amps alternator when the engine is turned on. The engine power reaches the wheels through a Hydro Gear 331-3000 hydrostatic transmission that provides the GTH 2754 infinite speeds traveling both forward and reverse. The rear wheels that drive the grass tractor measure each 23 × 10. 5-12 (23 inches in diameter, 10. 5 inches wide, 12 inches in tire diameter). The front wheels that run the cortesped measure 16 × 6. 5-8 (16 inches in diameter, 6. 5 inches of width, 8 inches of tire diameter).
The Husqvarna GTH2754 cutting platform is very large, with a 5 4-inch cutting width. Within this platform there are 3 blades that are operated by Correa. The platform is activated by means of an electric force. The cutting platform can be lifted up to a maximum of 3. 5 inches above the ground up to a minimum of 0. 5 inches above the ground. In this range, there are infinite cutting steps. Coupled to the platform, there are 4 anticaic wheels that are also sometimes known as calibrating wheels. These wheels prevent the platform from touching the ground and that the blades cut the earth.
The Husqvarna GTH2754 comes with a series of hours to you know exactly when you have to take it to review. The seat of this cortesped can be adjusted based on its height. If you are interested in other models that are as large as the GTH 2754, then you should check the Husqvarna GTH27V48LS or even the Husqvarna GTH26K54 Tractor Cortor.
