The Snapper Re200 is very similar to the Snapper RER13. 5/30 driver in many aspects. One reason is that both have the same power, 13. 5 hp. The other reason is that both have the same cutting width of 30 inches. However, most people see RE 200 as an improved version of RER 13. 5/30. The RE200 engine is an atk overhead valve avs. This engine of a cylinder is started with a 1 2-volt battery that provides 230 cold starting amps. This engine takes the power to the wheels first through a gear 510 hydrostatic hydro gearbox. This means that there is no change of march in this rear motor host.
Hydrostatic transmission provides Snapper RE200 for a maximum speed of 8 km/h (5 mph) in advance and a maximum speed of 3. 7 km/h (2. 3 mph) in reverse. The rear wheels operated by the engine measure 16 × 6. 5-8 (16 inches in diameter, 6. 5 inches of width, 8 inches in tire diameter), while the front wheels that run the host measure 13 × 5-6 (13 inches in diameter, 5 inches of width, 6 inches in tire diameter). The cutting platform has only one blade. It can be raised and declined mechanically to an infinite number of heights ranging from 2. 5 cm to 7. 5 cm above the ground.
Snapper RE200 fuel tank may contain up to 7. 6 liters of gasoline. The RE 200 frame has been manufactured with stamped steel that will not be easily damaged, while the front axle has been manufactured with welded steel that has a very long useful life. If you are buying this 3 0-inch brand new cutting, it comes with a limited 2-year warranty if you are buying if for residential use only. However, if you are buying it for commercial use, then it comes with a 9 0-day warranty for the machine and the 1 year limited warranty for the engine.
