The sel f-propelled cutter John Deere WG36A is a great thrust mapping. However, it uses the same engine as the John Deere WG32A. This is the Kawasaki FS481V engine that produces 16 hp. The bicylindrical engine has a displacement of 0. 603 liters. The fuel tank that supplies gasoline to this engine can contain up to 22 liters (5. 8 liters), which would indicate that this machine is often used by commercial contractors and crews that do not want to waste time by filing it constantly during the day. This power is transferred to the wheels through a 5-speed gearbox, giving the JD WG36a a maximum speed of 8. 7 km/h (5. 4 mph).
The John Deere WG36A wheels are quite large, which provides good traction without getting too much on the floor. They measure 13 × 6. 5-6 (13 inches in diameter, 6. 5 inches wide, 6 inches in tire diameter).
The cutting platform in the John Deere WG36A is built from a single continuous leaf of pressed steel 7, which means that the probability of cracking or damaging is much less than a cutting platform that has been weldedor screwed. The JD WG36A can handle a lot of grass thanks to its deep platform. The discharge duct of the corteped has risen and is wider than it would normally be on a cutting platform of this size to distribute the cuts over a broader area. The cuttin g-transmit platform with belt transmission has a 3 6-inch cut width, but obviously its total width is greater than this due to the discharge gate that is located on the side of it. If you need a larger sel f-propelled hostage in JD, then you should take a look at the sel f-propelled host of John Deere WG48A.
