The Zero Timecutter Z4235 Toro Toro Toro Specker is one of the smallest Timecutter top of bull. It is quite similar in size to the Timecutter Z4200 bull and the Timecutter SS4200 bull. The engine that drives the Z 4235 is a c o-rage engine of a Kohler cylinder. This engine is turned on with a 12 volt battery. The 4-stroke engine has a displacement of 0. 597 liters. The fuel tank supplied to the engine can contain up to 11. 4 liters. The total motor power is 19 hp.
The Timecutter Z4235 bull uses a double hydrostatic transmission to boost the wheels. The power addressed to each rear wheel is controlled by double comfort grip bars located in front of the driver. Remember that the rear wheels are responsible for both the speed and the direction of the Time Cutter Z 4235. These rear wheels each measure each 18 × 7. 5 (18 inches in diameter, 7. 5 inches of width). The front wheels are a little smaller, each measures 10 × 4 (10 inches in diameter, 4 inches wide). Dual hydrostatic transmission gives the Z4235 a maximum speed of 11. 3 km/h (7 mph) forward and 5. 5 km/h (3. 4 mph) when it goes back.
The Toro Timecutter Z4235 Cero Speaker Platform has a 4 2-inch cutting width. This platform of the corteped is made of stamped steel and has 2 blades. The operator can raise and lower the platform in the Timecutter Z4235 more than 3 inches, from a decrease of 1. 5 inches above the ground to a height of 4. 5 inches above the ground. The cutting platform rises and lowers manually using a sprin g-assisted manual lever. Although the cutting width of the corteped is 42 inches, its total width is 54 inches due to the plastic discharge lid on the side. You can also attach a rear tidner to the back of the cutter to collect the cuts.
